Mixing Valve Install

The Tank Mixing Valve Install

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #10523
    Roscoe
    Participant

    I am installing a mixing valve (Honeywell AM101C) on a Smart-40 indirect off a Triangle Tube Solo-110. What is the best options for piping this out? How close to the tank discharge of hot water? How much of a heat trap? Inverted? Is it wise to include a take-off for the 140* water for washer/dishwasher? Any advice/suggestions are welcomed. Thank you. 🙁

    #10548
    Larry Weingarten
    Participant

    Hello: Honeywell should have some installation guidelines. Beyond that, try asking your question at http://www.heatinghelp.com on “The Wall”. So much about your questions depends on the layout of the house’s plumbing.

    Yours, Larry

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.
Water Heater Rescue

You cannot copy content of this page