Reply To: Whirlpool waterheater over heating

The Tank Whirlpool waterheater over heating Reply To: Whirlpool waterheater over heating


Thanks Larry, that is good to know how to remove the thermistors clips. I had tried to wiggle them back and forth but didn’t get any where. I will try a little harder next time. If I did replace the thermistors do I just cut and splice the wire or do I have to fish the whole harness down from the top under the insulation?

I have left it running several times to see which code it was going to give me and it consistently blinks twice. I know the water is crazy hot so, something somewhere is not working. I just can’t put my finger on it.

Water Heater Rescue

You cannot copy content of this page