• a .75-inch-diameter standard magnesium combination (also known as outlet) anode rod (about 48 inches of overhead clearance needed)
• curved dip tube
• ball-valve drain assembly with cap
• Water Heater Workbook
• pipe thread seal tape
• instructions
• service sticker

Rheem/Ruud/Richmond/GE changed its design in about 2005 so that the hot-water port extends below the threads. To use a standard combo anode, one must drill out the port and even then, there is a risk that there will not be enough space between the hot-water outlet and the port wall to permit water to pass. The anode with this kit resolves that problem.

• The anode will keep your tank from rusting and breaking.
• The dip tube and drain assembly control sediment buildup by forcing water and sediment to swirl around the bottom of the tank and out.
• The ball valve has a relatively large diameter opening and a straight path, which make it harder for big sediment chunks to clog it, and easier to clear it if they do.
• The cap keeps the unwary from flooding the water heater space by accidentally opening the ball valve.
• The tape will make it easier to get the anode out to check its consumption down the road.
• The book will not only guide you to the installation of parts, but help you understand and resolve other water heater problems.
• The sticker will help you remember when you installed the parts.

• Pipe wrench
• adjustable pliers
• drill with 7/8-inch hole saw
• basin wrench
• hammer
• flat-bladed screwdriver.

The products offered here are designed to make water heaters last longer, or solve specific problems. Installation is potentially do-it-yourself, but if you have the least doubt about your abilities, we suggest that you obtain expert help.

Shipping is by UPS within the contiguous United States. UPS does not deliver to post boxes. Allow up to a about week for delivery. Hawaii and Alaska are only served by Priority Mail and can use a post box. We do not ship outside the United States.

1. Measure your water heater from the top to the drain valve and send the measurement to us at mail@waterheaterrescue.com. There are a few tanks that are shorter than average that require a shorter curved dip tube.

2. If you're getting a maximum-insulation tank, as we recommend, tell us so that we can include a 4-inch drain valve nipple.

If you have any doubts about what you're ordering, be sure and e-mail your questions to us. We want you to order only what you need!
mail@waterheaterrescue.com

$112, shipping included