Water Heater Rescue: Know-How, Solutions, Parts graphic
Go

Museum > Ewart & Son
Royal Geyser, ca. 1895

More Antiques:
Ewart Royal Geyser heater

Dating from about 1895, this British heater is gas-fired. It was installed in the bathroom next to the bathtub. Showers were virtually nonexistent. To operate, you light the pilot, turn on the water, then turn on the main gas.

Temperature is adjusted by putting in the right amount of cold water. When shutting it off you had to be careful not to shut off the water before turning off the gas. If you did forget, the heater would quickly be ruined, probably melted down!

The heater works by mixing hot gases and water, which although very efficient, wasn't particularly clean. British heaters have an interesting safety device built in that you can see on the side of it.

The "shepherd's crook" actually makes an air gap in the water supply. This prevents any tainted water from the heater from possibly getting back into the water supply, (a rather modern concept). The slightly tainted hot water was to be used only for bathing. This heater burns roughly 100,000 Btu per hour.

Back to Museum
Home | Site Map